Shopping Cart Shopping Cart - 0 item(s)
 Racing Clutches & Clutch Components
 Clutch Friction Plates
 Brake Pads
 Sprockets
 Accessories
 Instruction Manuals for Clutch & Accessories
 1/5 Scale RC Clutch
 Frame Slider Instructions
 Sliders
 





Instagram

Home > Frame Slider Instructions > EFS-12x Instructions
 

EFS-12x Instructions

Frame Sliders

 

Congratulations! You have just purchased the world’s finest frame sliders. These sliders have been designed to offer unsurpassed protection to your motorcycle in the unfortunate event of a crash or tip over. 

 

 

 

Important: Please read all instructions before beginning work! These Frame Sliders are designed to fit specific engine mounts of your motorcycle.  This kit has separate left and right pieces (left and right while sitting on the bike). It is highly recommended that you refer to your service manual before performing this installation. It is also recommended that a non-permanent thread lock compound be used.

 

 

 

 

Instructions:

1.   Remove the left-side engine mount nut. This nut may be very tight, so make sure you have the proper tool for the job. Save the nut for later.

2.     Remove the through bolt out the right hand side

3.     From the right side, install the shorter piece of plastic using the     supplied stud with nut already installed.

4.     Install the left side plastic and reuse the stock nut.

5.     Tighten the engine mount bolt to the factory specifications - DO NOT OVERTIGHTEN.

 

 

 

 

Included in this kit:

(1) 12mm x 400mm Stud, flange nut attached

(2) Aluminum bushings (pressed into plastic)

(2) Plastic Frame Sliders

        · Left (slightly longer piece)

        · Right (shorter piece)

     

Part No. FS-12x

Phone: (760-598-2105

Web: http://www.IntuRace.com