Shopping Cart Shopping Cart - 0 item(s)
 Racing Clutches & Clutch Components
 Clutch Friction Plates
 Brake Pads
 Sprockets
 Accessories
 Instruction Manuals for Clutch & Accessories
 1/5 Scale RC Clutch
 Frame Slider Instructions
 Sliders
 





Instagram

Home > Frame Slider Instructions > EFS-20 Instructions
 

EFS-20 Instructions

Frame Sliders

 

Congratulations! You have just purchased the world’s finest frame sliders. These sliders have been designed to offer unsurpassed protection to your motorcycle in the unfortunate event of a crash or tip over. 

 

Important: Please read all instructions before beginning work! These Frame Sliders are designed to fit specific engine mounts of your motorcycle.  This kit has separate left and right pieces (left and right while sitting on the bike). The longer slider (3.70”) is to be used on the left side.  It is highly recommended that you refer to your service manual before performing this installation.

 

Instructions:

1.     Remove the right side engine mount bolt, (rear most).

2.     Install the adapter plate and rotate towards the top, tighten to factory specs.  DO NOT OVERTIGHTEN.

3.     Install the plastic piece using a non-permanent thread-locking compound.

4.     Remove the left-side engine mount bolt, (forward most).

5.     Install the adapter plate and rotate towards the top, tighten to factory specs.  DO NOT OVERTIGHTEN

6.     Install the plastic piece using a non-permanent thread-locking compound.

 

 

FAIRING MODIFICATIONS

This kit requires a hole to be cut on the left side only.  The right will need a small notch.

It is suggested that you drill a small pilot hole to locate the slider. Once you have found the center, use a hole saw and cut a hole approximately 1 7/8” in diameter. Edges can be filed for perfect fit, or inaccuracies in drilling. We have found that placing masking tape on the area helps protect from scratches, cracks, etc.

 

 

Included in this kit:

(4) socket head bolts

        · 2 - 10 x 80mm

        · 2 - 10 x 50mm (for plastic to adapter)

(2) Special Adapters

(2) Aluminum bushings (pressed into plastic)

(2) Plastic Frame Sliders

        · left    longer piece               · right  shorter piece

 

Part No. FS-20

Phone: (760) 598-2105

Web: http://www.IntuRace.com