Shopping Cart Shopping Cart - 0 item(s)
 Racing Clutches & Clutch Components
 Clutch Friction Plates
 Brake Pads
 Instruction Manuals for Clutch & Accessories
 1/5 Scale RC Clutch
 Frame Slider Instructions

Home > Frame Slider Instructions > EFS-21x Instructions

EFS-21x Instructions

Frame Sliders


Congratulations! You have just purchased the world’s finest frame sliders. These sliders have been designed to offer unsurpassed protection to your motorcycle in the unfortunate event of a crash or tip over. 



Important: Please read all instructions before beginning work! These Frame Sliders are designed to fit specific engine mounts of your motorcycle.  This kit has separate left and right pieces (left and right while sitting on the bike).  It is highly recommended that you refer to your service manual before performing this installation.


The use of an impact wrench and a quality 6-point socket is recommended.




1.     Remove the left-side engine mount nut.

2.     Remove the through bolt, out the right hand side.

3.     From the right side, install the shorter piece of plastic, using the stud with the nut installed.

4.     Install the left side plastic, using the supplied large washer under the plastic.

5.     Tighten the engine mount bolt to the factory specifications - DO NOT OVERTIGHTEN.





It is suggested that you drill a small pilot hole to locate the engine mount. Once you have found the center, use a hole saw and cut a hole approximately 1 7/8” in diameter. Edges can be filed for perfect fit, or inaccuracies in drilling. We have found that placing masking tape on the area helps protect from scratches, cracks, etc.



Included in this kit:

(1) 12mmX370mm Stud, flange nut attached

(1) Washer,12mm Fender

(2) Aluminum bushings (pressed into plastic)

(2) Plastic Frame Sliders

      · Left (longer piece)

      · Right (shorter piece)


Part No. FS-21x                                                  Phone: (760-598-2105