Shopping Cart Shopping Cart - 0 item(s)
 Racing Clutches & Clutch Components
 Clutch Friction Plates
 Brake Pads
 Sprockets
 Accessories
 Instruction Manuals for Clutch & Accessories
 1/5 Scale RC Clutch
 Frame Slider Instructions
 Sliders
 





Instagram

Home > Frame Slider Instructions > EFS-22 Instructions
 

EFS-22 Instructions

Frame Sliders

 

Congratulations! You have just purchased the world’s finest frame sliders. These sliders have been designed to offer unsurpassed protection to your motorcycle in the unfortunate event of a crash or tip over. 

 

Important: These Frame Sliders are designed to fit specific engine mounts of your motorcycle.  This kit has separate left and right pieces (left and right while sitting on the bike).  The longer slider (3.125”) is to be used with the 70mm bolt on the left side.  It is highly recommended that you refer to your service manual before performing this installation.

 

Instructions:

1.   Remove the right-side engine mount bolt. (See Fairing Mods. Below)

2.   Install the shorter piece of plastic using the longer of the two bolts supplied in this kit. (refer to “Fairing Modification Instructions” below.)

3.   Tighten the engine mount bolt to the factory specifications - DO NOT OVERTIGHTEN.

4.     Loosen the pinch bolt on the left side.

5.     Remove the left-side engine mount bolt.

6.     Install the longer piece of plastic using the shorter of the two bolts supplied in this kit.

7.     Tighten the engine mount bolt to the factory specifications - DO NOT OVERTIGHTEN.

8.     Tighten the pinch bolt to the specified torque.

 

Fairing Modification Instructions

It is suggested that you drill a small pilot hole to locate the engine mount. Once you have found the

center, use a hole saw and cut a hole approximately 1 7/8” in diameter. Edges can be filed for perfect fit,

or inaccuracies in drilling. We have found that placing masking tape on the area helps protect from

scratches, cracks, etc.

 

Included in this kit:

(2) Flange head bolts

      · 1 - 10 x 70mm (left)

      · 1 - 10 x 80mm (right)

(2) Aluminum bushings (pressed into plastic)

(2) Plastic Frame Sliders

      · Left (longer piece)

      · Right (shorter piece)

 

Part No. FS-22

Phone: (760-598-2105

Web: http://www.IntuRace.com