Shopping Cart Shopping Cart - 0 item(s)
 Racing Clutches & Clutch Components
 Clutch Friction Plates
 Brake Pads
 Sprockets
 Accessories
 Instruction Manuals for Clutch & Accessories
 1/5 Scale RC Clutch
 Frame Slider Instructions
 Sliders
 





Instagram

Home > Frame Slider Instructions > EFS-25x Instructions
 

EFS-25x Instructions

Frame Sliders

                                  

Congratulations! You have just purchased the world’s finest frame sliders. These sliders have been designed to offer unsurpassed protection to your motorcycle in the unfortunate event of a crash or tip over. 

 

Important: These Frame Sliders are designed to fit specific engine mounts of your motorcycle.  This kit has separate left and right pieces (left and right while sitting on the bike). The longer slider (3.5”) is to be used with the 80mm bolt on the left side.  It is highly recommended that you refer to your service manual before performing this installation.

 

Instructions:

1.   Remove the left-side engine mount bolt.

2.   Install the slider using the new 10 x 80mm bolt  

3.     Tighten the engine mount bolt to the factory specifications - DO NOT OVERTIGHTEN.  Fairing Modifications will need to be performed on the left side. (see below)

4.     Loosen the pinch bolt on the right side.

5.     Remove the right side engine mount bolt.

6.     Install the shorter piece of plastic using the new 10 x 90mm bolt supplied in this kit and the thick washer.  Align the slider so the cut out clears the fairing.

7.     Tighten the engine mount bolt to the factory specifications - DO NOT OVERTIGHTEN.

8.     Tighten the pinch bolt to the factory specifications.

 

FAIRING MODIFICATIONS

It is suggested that you drill a small pilot hole to locate the engine mount.  Once you have found the center, use a hole saw and cut a hole approximately 1 7/8” in diameter.  Edges can be filed for perfect fit, or inaccuracies in drilling.  We have found that placing masking tape on the area helps protect from scratches, cracks, etc.

 

 

 

 

 

 

 


 

Included in this kit:

(2) Bolts

      · 1 - 10 x 80mm (left)      · 1 - 10 x 90mm (right)

(1) Thick washer (used on the right side, under the bolt head)

(2) Aluminum bushings (pressed into plastic)

(2) Plastic Frame Sliders

      · Left (longer piece)        ·Right (shorter piece)

      

Part No. FS-25x

Phone: (760-598-2105

Web: http://www.IntuRace.com