Frame Sliders

Instructions

Congratulations on purchasing the world’s finest frame sliders.  The frame sliders are to be mounted to your upper engine mounts.  It is suggested that you drill a small pilot hole to locate the engine mount.  Once you have found the center, use a hole saw and cut a hole approximately 1 7/8” - 2” in diameter.  Install the left side Ivrie Frame Slider, and torque to factory specifications.  DO NOT OVER TIGHTEN.  Then remove and replace the right hand side and torque to factory specifications.  DO NOT OVER TIGHTEN.  Refer  to your service manual before performing this installation.

Part No. FS-3

Phone:  760-598-2105

Web:  http://www.IntuRace.com