Shopping Cart Shopping Cart - 0 item(s)
 Racing Clutches & Clutch Components
 Clutch Friction Plates
 Brake Pads
 Sprockets
 Accessories
 Instruction Manuals for Clutch & Accessories
 1/5 Scale RC Clutch
 Frame Slider Instructions
 Sliders
 





Instagram

Home > Frame Slider Instructions > EFS-33 Instructions
 

EFS-33 Instructions


 

Frame Sliders

 

 

Congratulations! You have just purchased the world’s finest frame sliders. These sliders have been designed to offer unsurpassed protection to your motorcycle in the unfortunate event of a crash or tip over. 

 

 

 

 

 

Important: These Frame Sliders are designed to fit a specific engine mount of your motorcycle.  This kit has separate left and right adapters (left and right while sitting on the bike).  The longer adapter (2.5”) is to be used on the right side. It is highly recommended that you refer to your service manual before performing this installation.

 

 

Instructions:

1.   Support the front of the engine with a floor jack or car jack.

2.   Remove top middle motor mount, save the nut for step 5.

3.   Assemble new stud through the frame slider, then the appropriate adapter with the narrow side pointing towards the bike.  (see above)

4.     Install above assembly with the other adaptor and frame slider on the other side.

5.     Use the stock nut and torque to factory specs.

 

 

 

 

 

Included in this kit:

(1) Stud – 10mm x 442mm with 10mm x 1.25 locknut

(2) Aluminum Adapters (O-rings attached)

(2) Plastic Frame Sliders

(2) Aluminum bushings (pressed into plastic)

 

 

 

Part No. FS-33

Phone: (949) 586-0514

Web: http://www.IntuRace.com