Frame Sliders

Congratulations! You have just purchased the world’s finest frame sliders. These sliders have been designed to offer unsurpassed protection to your motorcycle in the unfortunate event of a crash or tip over. 

Important: These Frame Sliders are designed to fit specific engine mounts of your motorcycle. This kit has separate left and right pieces (left and right while sitting on the bike). It is highly recommended that you refer to your service manual before performing this installation. It is also recommended that a non-permanent thread lock compound be used.

Instructions:

1.   Remove the right-side engine mount bolt.

2.   Install the piece of plastic using the shorter of the two bolts supplied in this kit.

3.   Tighten the engine mount bolt to the factory specifications - DO NOT OVERTIGHTEN.

4.     Remove the left-side engine mount bolt.

5.     Install the slider (the one that has the bushing sticking through the back) using the longer of the two bolts supplied in this kit.

6.     Tighten the engine mount bolt to the factory specifications - DO NOT OVERTIGHTEN.

Included in this kit:

(2) Bolts

      · 1 - 10 x 70mm (left)

      · 1 - 10 x 60mm (right)

(2) Aluminum bushings (pressed into plastic)

(2) Plastic Frame Sliders

Part No. FS-38

Phone: (760-598-2105

Web: http://www.IntuRace.com