|
Frame Sliders
Congratulations! You have just purchased the world’s finest frame sliders. These sliders have been designed to offer unsurpassed protection to your motorcycle in the unfortunate event of a crash or tip over.
Important: These Frame Sliders are designed to fit specific engine mounts of your motorcycle. This kit has separate left and right pieces (left and right while sitting on the bike). The shorter slider (2.80”) is to be used with the 90mm bolt on the right side. It is highly recommended that you refer to your service manual before performing this installation. It is also recommended that a non-permanent thread lock compound be used.
Instructions:
1. Remove the left-side engine mount bolt.
2. Install the longer piece of plastic using the new 10 x 80mm bolt supplied in this kit.
3. Tighten the engine mount bolt to the factory specifications - DO NOT OVERTIGHTEN.
4. Loosen the pinch bolt on the right side.
5. Remove the right side engine mount bolt.
6. Install the shorter piece of plastic using the new 10 x 90mm bolt supplied in this kit.
7. Tighten the engine mount bolt to the factory specifications - DO NOT OVERTIGHTEN.
8. Tighten the pinch bolt to the factory specifications.
FAIRING MODIFICATIONS
GSXR600 (’04) and GSXR750 (’04) ONLY
A slight notch is required in the left side fairing, the use of a rotary tool is recommended.
*NOTE: IT IS RECOMMENDED THAT YOU CUT TOO LITTLE, RATHER THAN TOO MUCH. | | 
