Frame Sliders

Congratulations! You have just purchased the world’s finest frame sliders. These sliders have been designed to offer unsurpassed protection to your motorcycle in the unfortunate event of a crash or tip over. 

Important: Please read all instructions before beginning work! These Frame Sliders are designed to fit specific engine mounts of your motorcycle.  This kit has separate left and right pieces (left and right while sitting on the bike).  It is highly recommended that you refer to your service manual before performing this installation.

The use of an impact wrench and a quality 6-point socket is recommended.

Instructions:

1.     Remove the right-side lower-center engine mount nut.

2.     Remove the through bolt, out the left hand side.

3.     From the left side, install the left piece of plastic (larger spud) into the frame. Insert the stud provided with the nut installed through the plastic and into the frame. From the right side, install the right piece of plastic (smaller spud) onto the stud and thread the original nut.

4.     Tighten the nut to the factory specifications - DO NOT OVERTIGHTEN.

Included in this kit:

(1) 12mmX400mm Stud, flange nut attached

(2) Aluminum bushings (pressed into plastic)

(2) Plastic Frame Sliders

      · Left (large spud)

      · Right (small spud)

Part No. FS-46                                                    Phone: (760-598-2105

Web: http://www.IntuRace.com