Shopping Cart Shopping Cart - 0 item(s)
 Racing Clutches & Clutch Components
 Clutch Friction Plates
 Brake Pads
 Instruction Manuals for Clutch & Accessories
 1/5 Scale RC Clutch
 Frame Slider Instructions

Home > Frame Slider Instructions > EFS-47 Instructions

EFS-47 Instructions



Frame Sliders


Congratulations! You have just purchased the world’s finest frame sliders. These sliders have been designed to offer unsurpassed protection to your motorcycle in the unfortunate event of a crash or tip over. 



Important: Please read all instructions before beginning work! These Frame Sliders are designed to fit specific engine mounts of your motorcycle.  This kit has separate left and right pieces (left and right while sitting on the bike).  It is highly recommended that you refer to your service manual before performing this installation.


The use of an impact wrench and a quality 6-point socket is recommended for the removal of the stock nut.




1.     Remove the right-side lower-center engine mount nut (directly above the water pump).

2.     Remove the through bolt, out the left hand side.

3.     From the left side, install the left piece of plastic with the larger spud into the frame. Insert the stud provided with the nut installed through the plastic and into the frame. It may be necessary to utilize a second person to align the spacer on the right side while feeding the stud through the engine mount.

4.     From the right side install the right piece of plastic with the smaller spud onto the stud provided and thread the original nut.

5.     Tighten and torque the nut (55-60 ft. lbs. is recommended). - DO NOT OVERTIGHTEN. You may need a 17mm deep socket on the right side.


Included in this kit:

(1) 12mmX400mm Stud, flange nut attached

(2) Aluminum bushings (pressed into plastic)

(2) Plastic Frame Sliders

      · Left (large spud)

      · Right (small spud)


Part No. FS-47                                                    Phone: (760-598-2105