Shopping Cart Shopping Cart - 0 item(s)
 Racing Clutches & Clutch Components
 Clutch Friction Plates
 Brake Pads
 Sprockets
 Accessories
 Instruction Manuals for Clutch & Accessories
 1/5 Scale RC Clutch
 Frame Slider Instructions
 Sliders
 





Instagram

Home > Frame Slider Instructions > EFS-51 Instructions
 

EFS-51 Instructions

Frame Sliders

 

Congratulations! You have just purchased the world’s finest frame sliders. These sliders have been designed to offer unsurpassed protection to your motorcycle in the unfortunate event of a crash or tip over. 

 

Important: Please read all instructions before beginning work! These Frame Sliders are designed to fit specific engine mounts of your motorcycle.  This kit has separate left and right pieces (left and right while sitting on the bike).  It is highly recommended that you refer to your service manual for torque values and other pertinent information before performing this installation. It is also recommended that a non-permanent thread lock compound be used.

 

Instructions:

 

1.   Remove the left-side engine mount bolt (higher mount – nearest main frame spar).

2.     Install the left adapter bracket (short spud) with the new 10 x 70mm bolt, rotating it to between the 7 to 10 o’clock position.

3.     Tighten the engine mount bolt to the factory specifications - DO NOT OVER TIGHTEN.

4.     Install the shorter slider on the bracket and tighten fully. (Be sure to use a thread lock compound).

5.     Remove the right side engine mount bolt (same location as the left side).

6.     Install the right adapter (longer spud) using the new 10 x 80mm bolt supplied in this kit. Align the bracket to the 3 o’clock position.

7.     Tighten the engine mount bolt to the factory specifications - DO NOT OVER TIGHTEN.

8.     Install the longer slider on the bracket and tighten fully. (Be sure to use a thread lock compound).

 

Included in this kit:

(4) Bolts,

        · 1 – 10 x 80mm (right)

        · 1 – 10 x 70mm (left)

        · 1 - 10 x 50mm (long slider to right adapter)

        · 1 - 10 x 35mm (short slider to left adapter)

(2) Special Adapters

(2) Aluminum bushings (pressed into plastic)

(2) Plastic Frame Sliders

      · Left (shorter piece)           · Right (longer piece)

 

     

Part No. FS-51

Phone: (760-598-2105

Web: http://www.IntuRace.com