Shopping Cart Shopping Cart - 0 item(s)
 Racing Clutches & Clutch Components
 Clutch Friction Plates
 Brake Pads
 Sprockets
 Accessories
 Instruction Manuals for Clutch & Accessories
 1/5 Scale RC Clutch
 Frame Slider Instructions
 Sliders
 





Instagram

Home > Frame Slider Instructions > EFS-58x Instructions
 

EFS-58x Instructions

Frame Sliders

 

Congratulations! You have just purchased the world’s finest frame sliders. These sliders have been designed to offer unsurpassed protection to your motorcycle in the unfortunate event of a crash or tip over.

 

Important: These Frame Sliders are designed to fit specific engine mounts of your motorcycle. This kit has separate left and right pieces (left and right while sitting on the bike). Both sides mount directly to the engine mounts.  It is highly recommended that you refer to your service manual before performing this installation. It is also recommended that a non-permanent thread lock compound be used.  NOTE:  You will need to modify(notch) the fairing on the left side.

 

Instructions:

1.   Remove the left-side engine mount bolt, (be careful not to drop the nut on the inside).

2.     Install the slider with the bushing sticking through the back, using the shorter (90mm) bolt supplied in this kit. The thick washer should be placed through the bolt then through the slider.

3.     Tighten the engine mount bolt to the factory specifications. - DO NOT OVERTIGHTEN (you may need to hold the nut from behind).

4.     Remove the right side engine mount bolt, (be careful not to drop the nut on the inside).

5.     Install the piece of plastic with the recessed bushing using the 110mm (longer) bolt supplied in this kit. Place the thick washer through the bolt, then through the slider.  Align the slider so the cut out clears the fairing.

6.     Tighten the engine mount bolt to the factory specifications. Hold the slider firmly while tightening. - DO NOT OVERTIGHTEN. (You may need to hold the nut from behind).

 

 

Included in this kit:

(2) Bolts

        · 1 - 10 x 90mm (left)

        · 1 - 10 x 110mm (right)

(2) Aluminum bushings (pressed into plastic)

(2) Thick Washers

(2) Plastic Frame Sliders

        · Left (Bushing sticking out)              · Right (Recessed bushing)

 

    Part No. FS-58x

 

Phone: (949) 586-0514

Web: http://www.IntuRace.com