Shopping Cart Shopping Cart - 0 item(s)
 Racing Clutches & Clutch Components
 Clutch Friction Plates
 Brake Pads
 Instruction Manuals for Clutch & Accessories
 1/5 Scale RC Clutch
 Frame Slider Instructions

Home > Frame Slider Instructions > EFS-60 Instructions

EFS-60 Instructions

Frame Sliders


Congratulations! You have just purchased the world’s finest frame sliders. These sliders have been designed to offer unsurpassed protection to your motorcycle in the unfortunate event of a crash or tip over. 


Important: These Frame Sliders are designed to fit specific engine mounts of your motorcycle.  This kit has separate left and right pieces (left and right while sitting on the bike).  It is highly recommended that you refer to your service manual before performing this installation. It is also recommended that a non-permanent thread lock compound be used.






1.   Remove the left-side engine mount bolt (behind the removable mid-fairing.).

2.     Install the left adapter bracket (offset) with the new 10 x 70mm bolt, rotating it to between the 7 to 9 o’clock position

3.     Tighten the engine mount bolt to the factory specifications - DO NOT OVERTIGHTEN.

4.     Install the slider on the bracket and tighten fully. (Be sure to use a non-permanent thread lock compound)

5.     Remove the right side engine mount bolt.

6.     Install the right adapter (round) using the new 10 x 100mm bolt(inserted through the slider) supplied in this kit.

7.     Tighten the engine mount bolt to the factory specifications - DO NOT OVERTIGHTEN.


Included in this kit:

(3) Bolts

        · 1 - 10 x 100mm (right)

        · 1 - 10 x 50mm (left - slider to adapter)

        · 1 - 10 x 70mm (left)

(2) Special Adapters (round adapter – right side)

(2) Aluminum bushings (pressed into plastic)

(2) Plastic Frame Sliders



Part No. FS-60

Phone: (760-598-2105