Shopping Cart Shopping Cart - 0 item(s)
 Racing Clutches & Clutch Components
 Clutch Friction Plates
 Brake Pads
 Sprockets
 Accessories
 Instruction Manuals for Clutch & Accessories
 1/5 Scale RC Clutch
 Frame Slider Instructions
 Sliders
 





Instagram

Home > Frame Slider Instructions > EFS-65 Instructions
 

EFS-65 Instructions


Frame Sliders

 

Congratulations! You have just purchased the world’s finest frame sliders. These sliders have been designed to offer unsurpassed protection to your motorcycle in the unfortunate event of a crash or tip over.
 

 

Important: These Frame Sliders are designed to fit specific engine mounts of your motorcycle. This kit has separate left and right pieces (left and right while sitting on the bike). The slider is to be used with the 150mm bolt on the right side.  It is highly recommended that you refer to your service manual before performing this installation. It is also recommended that a non-permanent thread lock compound be used.

Instructions:

1.   Remove the FRONT engine mount bolt.

2.       Install the shorter ALUM. SPACER using the new 10 x 150mm bolt supplied in this Kit ON RIGHT SIDE

3.     Tighten the engine mount bolt to the factory specifications - DO NOT OVERTIGHTEN.

.

 

Included in this kit:

2) FLANGE  Head bolts

        · 1 - 10 x 150mm (left)

        · 1 - 10 x 150mm (right)

(2) Aluminum bushings (pressed into plastic)

(2) Plastic Frame Sliders

        · Left SPACER LONGER                   · Right  SPACER SHORT

  

Part No. EFS-65

 

Phone: (760-598-2105

Web: http://www.IntuRace.com