Shopping Cart Shopping Cart - 0 item(s)
 Racing Clutches & Clutch Components
 Clutch Friction Plates
 Brake Pads
 Sprockets
 Accessories
 Instruction Manuals for Clutch & Accessories
 1/5 Scale RC Clutch
 Frame Slider Instructions
 Sliders
 





Instagram

Home > Frame Slider Instructions > EFS-66 Instructions
 

EFS-66 Instructions

Frame Sliders

 

Congratulations! You have just purchased the world’s finest frame sliders. These sliders have been designed to offer unsurpassed protection to your motorcycle in the unfortunate event of a crash or tip over
 
Important: These Frame Sliders are designed to fit specific engine mounts of your motorcycle. This kit has separate left and right pieces (left and right while sitting on the bike). The shorter slider is to be used with the 90mm bolt on the right side.  It is highly recommended that you refer to your service manual before performing this installation. It is also recommended that a non-permanent thread lock compound be used.

 

 

 
Instructions:

1.   Remove the left-side engine mount bolt.

Install the longer piece of plastic using the new 10 x 90mm bolt supplied in this Kit

Tighten the engine mount bolt to the factory specifications - DO NOT OVERTIGHTEN.

Loosen the pinch bolt on the right side.

Remove the right side engine mount bolt.

Install the shorter piece of plastic using the new 10 x 90mm bolt supplied in this Kit.

Tighten the engine mount bolt to the factory specifications - DO NOT OVERTIGHTEN.

Tighten the pinch bolt to the factory specifications.
 

Included in this kit:

(2) Socket  Head bolts

        · 1 - 10 x 90mm (left)

        · 1 - 10 x 90mm (right)

(2) Aluminum bushings (pressed into plastic)

(2) Plastic Frame Sliders

        · Left (longer piece)                            · Right (shorter piece)

     

Part No. EFS-66

 

Phone: (1-760-598-2105

Web: http://www.IntuRace.com