|
Frame Sliders
Congratulations! You have just purchased the world’s finest frame sliders. These sliders have been designed to offer unsurpassed protection to your motorcycle in the unfortunate event of a crash or tip over.
Important: These Frame Sliders are designed to fit specific engine mounts of your motorcycle. This kit has separate left and right pieces (left and right while sitting on the bike). The left and right pieces both mount directly to the engine mounts. The longer slider is to be used on the left side. It is highly recommended that you refer to your service manual before performing this installation. It is also recommended that a non-permanent thread lock compound be used.
Instructions:
1. Remove the left-side engine mount bolt (10mm Allen head). Leave the washer in place in the frame bolt counter bore.
2. Place one of the supplied washers over the bolt, then place the bolt through the longer slider. Make sure the original (stock) washer is still in the frame bolt counter bore.
3. Tighten the engine mount bolt (17mm head) to the factory specifications - DO NOT OVERTIGHTEN.
4. Remove the right-side engine mount bolt (10mm Allen head). Leave the washer in place in the frame bolt counter bore.
5. Place two of the supplied washers over the bolt, then place the bolt through the slider. Make sure the original (stock) washer is still in the frame bolt counter bore.
6. Tighten the engine mount bolt (17mm head) to the factory specifications - DO NOT OVERTIGHTEN. | 
