Shopping Cart Shopping Cart - 0 item(s)
 Racing Clutches & Clutch Components
 Clutch Friction Plates
 Brake Pads
 Sprockets
 Accessories
 Instruction Manuals for Clutch & Accessories
 1/5 Scale RC Clutch
 Frame Slider Instructions
 Sliders
 





Instagram

Home > Frame Slider Instructions > EFS-80 Instructions
 

EFS-80 Instructions

Frame Sliders

 

Congratulations! You have just purchased the world’s finest frame sliders. These sliders have been designed to offer unsurpassed protection to your motorcycle in the unfortunate event of a crash or tip over. 

 

Important: These Frame Sliders are designed to fit specific engine mounts of your motorcycle.  This kit has separate left and right pieces (left and right while sitting on the bike).  It is highly recommended that you refer to your service manual before performing this installation. It is also recommended that a non-permanent thread lock compound be used.

 

 

 

Instructions:

 

1.   Remove the left-side lower engine mount bolt

2.     Install the left adapter bracket (offset) with the new 10 x 110mm bolt

3.     Tighten the engine mount bolt to the factory specifications - DO NOT OVERTIGHTEN.

4.     Both sides are the same to install ,slider is pre assembled

5.     Remove the right side engine mount bolt.

6.     Install the right adapter using the new 10 x 110mm bolt.

7.     Tighten the engine mount bolt to the factory specifications - DO NOT OVERTIGHTEN.

 

Included in this kit:

(2) Bolts

        · 2 - 10 x 120mm (left)

       

       

(2) Special Adapters round

(2) Aluminum bushings (pressed into plastic)

(2) Plastic Frame Sliders

 

     

Part No. FS-80

Phone: (760-598-2105)

Web: http://www.IntuRace.com